APC USB TO SERIAL SMART SIGNALING CABLE DRIVER DOWNLOAD

To do that, you need to disconnect everything including serial cable , and then turn off and disconnect any load. Long story short, I was able to configure network adapter using telnet. I am NOT familiar with the latter. It all fails miserably! Choose a location discussion: The documented pinout looks like a simple null-modem cable swapping the TX and RX pins:

Uploader: Tuzuru
Date Added: 17 September 2017
File Size: 7.80 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83505
Price: Free* [*Free Regsitration Required]

APC USB to Serial Db9 Rs-232 Smart Signaling Cable 940-0272

Sign up or log in Sign up using Google. Hi, Hope someone can help. Shouls i use the USB to serial cable afterwards then?

Sign up using Facebook. You can also verify everything still shows in Device Manager. Part is printed on one of the connectors.

Server Fault works best with JavaScript enabled. Post as a guest Name. The UPS unit uses an AP network card, but also has what looks seria be a serial port for terminal use putty is awesome. For this UPS, then you have to disconnect the battery on it and you can hold down the off button for seconds so we can discharge the UPS completely and ultimately do the braindead.

We need to get the USB to serial adapter installed first and make sure its recognized before we go further. The documented pinout looks like a simple null-modem cable swapping the TX and RX pins:.

  ACER ASPIRE 4935G DRIVER

USB to serial adapter

Email Required, but never shown. I have read that USB to serial may not work with some models although the cable shipped with the device?

By using our site, smxrt acknowledge that you have read and understand our Cookie PolicyPrivacy Policy sugnaling, and our Terms of Service. Well, it may be proprietary in the sense of it being a non standard pinoutbut you can find pinout diagrams if you know what you are looking for, and if you have a few inexpensive tools, you can also make one. Chad Harrison 3, 10 22 Hi – Just managed to test the UPS following the ‘braindead’ procedure but no joy!

To do that, you need to disconnect everything including signalnig cableand then turn off and disconnect any load. I am NOT familiar with the latter. However, Tto have here in hand a Cisco YC Cable that looks like it could work, but I am having hard time trying to find the wire configuration to see if they would match up. Choose a location discussion: Michael Kohne 1, 1 13 Sign up using Email and Password. Long story short, I was able to configure network adapter using telnet.

  ABIT A-N68SV SOUND DRIVER

USB to serial adapter | UPS Management Devices & PowerChute Software

This website may contain content submitted by users and is for sighaling purposes only. So we disconnect everything and then drain any residual power from the device.

Also, the USB to serial adapter requires a driver by Prolific – have you installed this? Home Questions Tags Users Unanswered. It might be helpful to also braindead the UPS and try again with the laptop.

First, not sure if this question belongs here or SU, so please advice accordingly before wildly down-voting or blasting me. Then, turn off the UPS and unplug it. If the cable wiring diagram given at this page is accurate, then it’s basically just pins 2,3, and ground. Steps attempted thus far: For whatever reason, when we reboot our machine that we had configured for auto-shutdown with our UPS unit, the NIC on the UPS serjal just dropped it’s IP configuration still trying to figure that one out.