Here is the script I run on each iSCSI Boot initiator you would obviously change the ip number to suit your environment:. Wednesday, November 23, 9: Thanks for posting here. If system will keep binding the default route to this interface even if we empty the gateway entry on this interface ,we might also try to change the interface binding to make the interface I don’t want my iSCSI traffic to ever show up with a default route. I have configured them to use iSCSI boot the primary looks to
|Date Added:||8 May 2006|
|File Size:||56.53 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I don’t want my iSCSI traffic to ever show up with a default route. Yes I can script it. Then I can type:.
The target is configured correctly. I knew some settings that we set at OS level will be overrode by such software. How do I get rid of it? Sign in to vote. Wednesday, November 23, 6: I had to first determine the “interface number” of the NICs from the route print command:.
Dependent hardware iSCSI adapter on ESXi5 – Gabes Virtual World
Tuesday, November 4, 5: I agree that changing the routing metric on the interfaces is the solution. Easiest is to right click the vmhba adapter and iiscsi the properties tab.
Thursday, November 24, 7: I tried to explicitly remove the 0. I was able to delete them manually from the command line.
As you can see with the above routing table traffic attempts to travel over these routes: A ping to the outside world first attempts on Office Office Exchange Server. Not an IT pro? Reboot and you should be good. To connect the second vmhba, you should follow the same steps again.
Learn Which Adapters Support Intel® iSCSI Remote Boot
If system will keep binding the default route to this interface even if we empty the gateway entry on this interface ,we might also try to change the interface binding to make the interface On the first tab you can set CHAP authentication if needed.
I did not configure a default route in the Intel intwl utility: This may be many years too late but I think I may have a solution for this.
Tuesday, July 21, 9: 82567 easiest test is to just shutdown the port on the physical switch connected to the first vmhba and then see if the failover works. Software Loopback Interface 1 After pressing OK and a rescan of the vmhba, you should now see the LUN s that have been presented to your host.
Saturday, May 23, Here is the script I run on each iSCSI Boot initiator you would obviously change the ip number to suit your environment:. Tuesday, November 22, 2: I insured that my DHCP server gave out no default gateway entry.
Have you installed any NIC configuration software from Intel on this server? Wednesday, November 23, 9: